GREAT PLAINS YP-425, Operator'S Manual

Page: 33 / 134

YP-425, 625, 825, & 1025-A3P Table of Contents Index Operating Instructions 29
2018-07-23 Table of Contents Index 401-652M
Machine s/n:
YP425A3P s/n B1007M thru B1015M
YP625A3P s/n B1009P thru B1041P
YP825A3P s/n B1014R thru B1268R
YP1025A3P s/n C1001U-
Refer to Figure 17
The capacity of this hopper is 1.6 bu.
Within the serial number range listed above, there are
two different designs of hopper lids. Make sure you follow
the correct instructions for the hopper lids used on your
machine.
Late Production Hopper Lids
1. Late production hopper lids : are held in place by a
mounting plate and a draw handle .
2. Unlatch the draw handle and lift lid off.
3. Prepare the hopper for loading by setting the lid
aside.

The seed hoppers themselves are designed to be
removed, but are not removed for routine operations.
Early Production Hopper Lids
Refer to Figure 18
1. Early production hopper lids : are held in place by
two spring clips, one at each end . There is a
molded handle at the rear end of the hopper lid
(although the lid is reversible).
2. Grasp the handle and snap lid off.
Refer to Figure 19
3. Prepare the hopper for loading by storing the lid
lengthwise on the side lip of the hopper, using the
hooked ends of each spring clip inside the lid.

The seed hoppers themselves are designed to be
removed, but are not removed for routine operations.
Figure 16
Late Production Hopper Lid
36910
10%
3
2
1
1
2 3
Figure 17
Early Production Hopper Lid
32446
1
2
3
1
2
3
Figure 18
Hopper Lid Stored for Loading
32447