Great Plains
| 586-537Q-ENG | 04/26/2019
36
3500-4000TM
Assembly
Rear Stand
If machine is equipped with a rear attachment, be sure you
install the rear jack stand so machine doesn’t tip backwards
when unhooking machine from tractor.
145.Attach the rear stand bracket to the center of, the rear
tube of the drag frame with
5
8
x 3
1
32
x 4
1
2
u-bolts ,
5
8
lock washers and nuts.
146.Tighten u-bolts specs, See “
147.Slide the rear stand through the rear stand bracket ,
secure with the
3
4
x 5
1
4
pin and retainer.
148.Once the options are installed, fold the Turbo Max to
check for clearance and interferences, also watch that
hoses do not get pinched.
Double check that all bolts are tightened to specs,
” on page 38.Consult the
“Operator’s Manual”, for the first time field
adjustments before going to the field.
Weight Package Assembly (Optional)
Lower machine until coulters are on ground and pressure is off
leveling system.
Up to 2 sets of weights (4 weights) may be installed in
positions shown.
149. Start by removing the
3
4
x 2 Gr. 8 bolts from level bar
assembly.
150.Pivot level bar up so there will be clearance to set the
750 pound weight assemblies into place.
151.Pivot level bar spring assembly forward.
152.Carefully lower the 750 pound weight assemblies (4
maximum) onto center frame trusses , two on front side
of fold cylinders and two on rear side of fold cylinders.
153.Slide rear weights as far forward as possible and install
weight box stops on inside of trusses as close to weight
as possible (rear weights), secure with
1
2
x 4
1
32
x 5
1
4
u-
bolt ,
1
2
lock washers and nuts.
154.Torque bolts to 85 ft-lbs.
4
3
1
2
Figure 34
Rear Stand
42438
1
2
3
1
4
2
3
6
7
1
4
4
5
5
Figure 35
Weight Package
42407
1
2
4
3
4
5
6
7
