GREAT PLAINS TCN5107, Operator'S Manual, Page: 26 / 78

Great Plains | 566-170M | 04/26/2019 Table of Contents Index 20
TCN5107-5313 Table of Contents Index Preparation and Setup
Refer to Figure 5
4. Rear jack should be lowered to ground when machine is
in parking position to keep machine from tipping over
backwards. Adjust rear jack up off ground to allow for
front jack to be adjusted.
5. Use front jack to raise and lower turbo-chisel tongue.
6. Remove hitch pin from tractor draw-bar.
7. Back tractor draw-bar into alignment with hitch . Set
tractor parking break.
8. Secure with a locking hitch pin.
9. Secure safety chain to an anchor on the tractor .
Refer to Figure 6
10. Retract jack foot.
11. After hitching tractor to turbo-chisel, store front jack on
storage stob on Turbo-Chisel tongue.
12. Remove pin from rear jack ( Figure 5 ), move to front
outside tube of center frame storage stob ( Figure 6 ) and re-
install pin.
13. Remove pin in jack stand tube ( Figure 5 ) and raise tube
up to top hole, re-install pin.
Electrical Hookup
Refer to Figure 7
Make sure tractor is shut down with accessory power off before
making connections.
14. Mate lighting connector to tractor outlet.
15. Mate any optional or after-market electrical connectors.
16. Make connections prior to TCN5107-5313 movement.
4
Figure 5
Front & Rear Jack (Parking)
41993
42162
1
3
2
6
1
2
2
3
4
1
Figure 6
Jacks in Storage
42178
2
5
1
6
Figure 7
Lighting Connector European (North
American)
41995
36051