GREAT PLAINS NTA3007HD, Operator'S Manual

Page: 23 / 178

NTA907HD and NTA3007HD Table of Contents Index Preparation and Setup
Great Plains | 166-207M | 02/26/2019 Table of Contents Index 17
Preparation and Setup
This section helps you prepare your tractor and NTA907/
3007HD Drill for use, and covers seasonal tasks, and
task when the tractor/Air Drill configuration changes.
Before using the NTA907/3007HD Drill in the field, you
must hitch the Air Drill to a suitable tractor, inspect
systems and level the Air Drill. Before using the Air Drill
for the first time, and periodically thereafter, certain
adjustments and calibrations are required.
Initial Setup
See “ Appendix B - Initial Setup ” on page 162 and
“ Appendix C - Option Installation ” on page 164 for pre-
delivery items (normally completed by dealer), and first-
time/infrequent setup tasks, including:
•
Install seed monitor console in tractor (page 162).
•
Set marker extension (page 162) and speed.
Seasonal Setup
On initial delivery, use with a new tractor, and seasonally,
check and as necessary, complete these items before
continuing to the routine setup items:
•
Bleed hydraulic system (page 111).
•
Wing leveling and alignment (page 127).
•
Speed sensor calibration (DICKEY-john Air Cart
Control manual).
•
Blow out entire air system to remove condensation.
Check air flow at each row, for evidence of plugging.
•
De-grease exposed cylinder rods if so protected at
last storage.
Pre-Planting Setup
Complete this checklist before routine setup:

Read and understand “ Important Safety
Information ” on page 1.

Check that all working parts are moving freely, bolts
are tight, and cotter pins are spread.

Check that all grease fittings are in place and
lubricated. See “
Lubrication ” on page 132.

Check that all safety decals and reflectors are
correctly located and legible. Replace if damaged.
See “
Safety Decals ” on page 6.

Inflate tires to pressure recommended and tighten
wheel bolts as specified. See “
Tire Inflation Chart ”
on page 144.