GREAT PLAINS HT1100-40, Operator'S Manual, Page: 15 / 38

Page
15
OPERATION MANUAL
Set Up / Operation
Wiring Instructions:
1) After mounting hopper convergent location for operator.
2) Locate wire components from parts carton and hardware bags.
3) Connect the ring terminals to a 12-volt power source. White Wire (+) Black Wire (-)
4) Connect the two 12 foot wire harness (L03-0003-010) to connectors on console and rout to connectors located
on hopper. Install one piece of black flex guard to each wire harness.
5) Mounting the Run/Hold Switch. The Run/Hold switch is wired from the factory to be nominally closed.
The chain has to be pulled to release the switch to stop the electric motor. Note: The Run/Hold switch only
turns on or off the electric motor. For stopping for long periods of time shut-off the center master switch to
cut all power to motor and clutches. Mount run/Hold switch per instructions.
7) Connect wire (62181-10) from console back to hopper and connect to run\hold adaptor wire (62253-6).
Connect wire (62253-5) to wire adaptor and rout back and connect to Run/Hold switch. Connect run\hold
adaptor wire to wire from electric motor.
8) If Run/Hold switch is not needed connect wire 62181-10 to wire from electric motor.
This will by-pass the Run\Hold switch.