GREAT PLAINS 7000 Series, Predelivery Manual

Page: 19 / 38

7000 Series Disk Table of Contents Index Assembly
Great Plains | 556-427Q | 2020-01-16 Table of Contents Index 15
C-Shank Alignment-Disc Gang Assembly
Refer to Figure 12
33. If gangs are removed from the gangbar for maintenance,
care must be taken to re-align the parts correctly during
re-assembly. See figure below for the proper C-shank
alignment dimensions and pre-assembly procedures.
Null4.aac:
34. At this time the unit should be checked over for any loose
bolts. Air pressure in the tires should be checked, See
“
Tire Inflation & Warranty ” on page 17. Refer to the
lubrication section of the “Operators Manual” for the
lubrications for this machine. If there is any rear
attachment, it should be installed at this time.
If machine is equipped with a rear attachment, be sure you
install the rear jack stand, see “Parts Manual” Rear Jack
Stand, so machine doesn’t tip backwards when unhooking
machine from tractor.

Double check that all bolts are tightened to specs, See
“ Torque Values Chart ” on page 14.Consult the
“Operator’s Manual”, for the first time field adjustments
before going to the field.
4
3
2
1
Figure 12
C-Shank Alignment-Disc Gang
43464