GREAT PLAINS 2N-2410, Operator'S Manual

Page: 38 / 64

2N-2410 & 2N-3010 Table of Contents Index Adjustments 35
8/2/18 Table of Contents Index 196-126M
Individual Coulters
Refer to Figure 17
When coulters follow in tire tracks and do not give
satisfactory depth, individual coulters can be lowered
by loosening the mounting clamps and adjusting the
coulter to the desired setting.
To tighten clamps, snug the hex-head clamp bolts (1)
just until the U-bolts are tight on each side of the spring
bar. Tighten nuts on U-bolts (2), then finish tightening
the hex-head clamp bolts.
Never lower any coulter more than 1 1/2 inches. Tire damage
could result as the drill is folded. Also note that when the drill
is in the raised position, ground clearance on lowered coulters
is reduced.

There may be as much as a 1/8-inch gap between
the clamp plates even when the coulter is mounted
securely.
10300
Figure 17
Individual Coulter Height Adjustment