706/1006NT
Table of Contents
Setup
21
01/22/2018
Table of Contents
150-285Q
Scraper Installation
Optional carbide disk scrapers are not factory installed.
1.
Remove one or both disk blades to gain safe access
to the mount. Note the position of bushings and
spacers for correct re-assembly (see Operator
Manual).
2.
Remove the existing slotted scraper.
Refer to Figure 21
3.
If Seed-Lok is present, or also being mounted, do not
use the hex nut (1) supplied with the scraper, and
place the lock washer (2) under the bolt (3) head.
4.
Place the flat washer (4) on the bolt (3).
5.
Insert the bolt through the scraper blades (5), the
spacer (6), and the mount (7). Secure with lock
washer (2) and hex nut (1) (If Seed-Lok is present,
screw bolt into thread hole in Seed-Lok).
6.
If the blade spring (8) was not pre-assembled,
connect it between the upper holes of the blades (5).
7.
Tighten bolt (3).
8.
Re-mount the removed disk blade.
Install Other Options
Prior to Setup, install any other optional features that
were not factory-installed, such as Native Grass,
Fertilizer, Small Seeds, Agitator, Seed Firmers and
Harrow. These options include their own Installation
Instructions.
Figure 21
Scraper Installation
19000
2
1
5
8
3
4
6
7
