01/22/2018
Table of Contents
150-285Q
706/1006NT
Table of Contents
Assembly
12
Secure Tongue
Refer to Figure 6
6.
Insert all four U-bolts (32), and add lock washers
(28) and nuts (23), finger tight.
7.
Make final side-to-side leveling adjustments, and
tighten all nuts (23) to torque specifications.
Lamp Installation
The lights may be assembled on the drill, or may be
shipped in the seed box or separately to prevent damage
to the lighting system during transport and loading.
If the drill is delivered with the lights not assembled, the dealer
must assemble the lights on the drill prior to selling the drill.
Refer to Figure 7 and Figure 8
1.
At one end of the drill, install a spacer (1), lamp
bracket (2), and handle (3) using two 1/2-13 x 1 inch
bolts (4) and two flange lock nuts (5).
NOTE:
Make sure the horizontal flange of the lamp bracket is
toward the front of the drill.
2.
Install an amber lamp (6) on outside of the bracket
with two 1/4-20x3/4 inch self tapping screws (7).
3.
Install a red lamp (8) on the inside of the bracket with
two 1/4-20x3/4 inch self tapping screws (7).
Make sure the lamps are installed as instructed, with the
amber lamp on the outside and the red lamp on the inside.
4.
Install a hose clip (9) to the lamp bracket with a
3/8-16x3/4 bolt (10), lock washer (11), and nut (12).
5.
Secure the wiring harnesses to the hose clip.
6.
For 1006NT only
- Place a red reflector (13) on the
lamp bracket facing rearward.
7.
Repeat the procedure for the other lamp set.
Figure 6
Secure Tongue
21719
28
23
32
2
1
1
4
3
2
5
6
7
68366
1
8
Figure 7
Lamp Installation
68372
13
11
12
9
10
Figure 8
Reflector Installation
