Note: The two holders need to be snapped into the groove in the same direction.
3. Install four treads to the holder, see the picture as below. Fix the top tread to the holder by #10x1-1/4 screws.
4. Fix the left and right fi xing strips with bolt & gasket( M6), and nut M6*85!, do not over tighten (the accessories are
in screw kit 5862050002 )
5. Use # 10x1-1 / 4 screws to fi x other three treads. Then put aside for further processes.
Holder
Need to be fi xed by screw
Tighten with screws for both right and lift
sides
Bolt
Gasket
Nut
Left fi xing strip
Right fi xing strip
Fix the treads to the left and right fi xing
strips with screws
Tighten with two screws for both sides
