First Contact
M20 PIX Machine - Electronic Engraving machine . 17
7 6 5 4
3
2 1 0 1 2
3
4 5 6 7
7 6 5 4
3
2 1 0 1 2
3
4 5 6 7
5. Choose the jigs (T) according to the length of the plate (consult your GRAVOGRAPH dealer for
more information on the various jigs available).
The length of the plate should not exceed the length of the jigs:
6. Choose adequate side of the jigs (T) according to the thickness of the plate.
The plate should be slightly higher than the jigs to avoid that the regulating nose touches the jigs:
7. Mark the middle of the plate (not necessary if you use the "Point of shoot (PnS)" function).
8. Centre the plate so that the centre mark is lined up with the 0 on the jig
(origin centre ) :
9. Using the tightening knob, tighten the plate so that it cannot move during engraving.
If the plate is correctly tightened, noise and vibrations are reduced to a minimum when the machine is engraving.
Check that the object is tightened correctly to ensure that it is not ejected during engra
-
ving.
Check that the jigs (T) are removed and that the vice is opened as much as possible be
-
fore using the pen attachment.
