GB - 23
ADJUSTING THE HEIGHT OF THE
STEERING LEVER HANDLES
The handles have three height positions
(Figure 13).
1. Shut OFF engine. Engage parking
brake. Remove the ignition key.
2. Remove the spacer, handle, and
eccentric spacer from the steering lever.
NOTE:
Position the right and left handles at
the same height position.
3. Install the spacer, handle, and eccentric
spacer in the appropriate height position.
Do not tighten the nut holding the
eccentric spacer.
4. Turn the eccentric spacer until the right
and left handles are the same height.
Tighten nut.
ADJUSTING THE PARKING
BRAKE
The parking brake might need adjustment
over time and after new brake paddles have
been installed.
Check Parking Brake Adjustment
NOTE:
Be sure to check the parking brake on
both sides of the unit (Figure 14).
1. Disengage parking brake.
2. Measure the distance between the
bottom edge of the brake paddle and the
tire.
Figure 12
1. Limiter Bolt
2. Jam Nut
3. Steering
Lever
4. Stop
Bracket
Figure 13
OF3745
1. Spacer
2. Handle
3. Eccentric
Spacer
4. Steering
Lever
Position 1
Position 1
Position 1
1. Parking
Brake Paddle
2. Brake Rod
3. Clevis
4. Return
Springs
5. Hair Pin
6. Clevis Pin
Figure 14
OF3303
3/8 in. - 1/2 in. (9.5 -
15.9 mm)
Summary of Contents for 99108 Compact Pro 34
Page 35: ......
