GB - 22
Handlebar Stop Adjustment
(Figure 22 and 23)
NOTE: If either side of handlebar weldment is
rubbing on seat support the handlebar stop
needs adjustment.
Turn adjustment screw clockwise or
counterclockwise until handlebar weldment
does not rub on seat support.
PTO BELT REPLACEMENT
Remove (Figure 24)
1. Lower mower deck to the ground.
2. Remove belt covers from mower deck.
3. Hook a puller into idler hole and pull idler
arm towards outside of unit until tension
is removed from PTO belt.
4. Remove PTO belt from left mower deck
pulley.
5. Slowly release idler arm until tension is
removed from idler spring.
6. Remove PTO belt from mower deck and
electric clutch.
Install (Figure 24)
NOTE: Do not install PTO belt on left mower
deck pulley in step 1.
1. Install PTO belt on electric clutch and
mower deck.
2. Hook a puller into idler hole and pull idler
arm towards outside of unit until PTO
belt can be routed around left mower
deck pulley.
3. Slowly release idler arm until idler pulley
rests firmly against PTO belt.
4. Install belt covers on mower deck.
1
OE0046
Figure 23
3
1. Adjustment
Screw
2. Handlebar Stop
3. Handlebar
Weldment
2
CAUTION: Use care when releasing
idler spring tension. Keep body parts
well away from idler when performing
this operation.
Figure 24
7
OE0080
3
1. Idler Spring
2. Electric Clutch
3. PTO Belt
4. Idler Hole
5. Idler Pulley
6. Idler Arm
7. Belt Cover
1
2
4
6
5
