GB - 19
3. Check mower blade balance by sliding
mower blade on an unthreaded bolt. If
blade is balanced, it should remain in a
horizontal position. If either end of
mower blade moves downward, sharpen
the heavy end until mower blade is
balanced.
4. Install mower blade on unit (see Mower
Blade Replacement on page 18).
ANTI-SCALP ROLLER
ADJUSTMENT
NOTE: The anti-scalp rollers are intended to
prevent lawn scalping, not to control cutting
height. All anti-scalp rollers should be set at
the same height.
See figure 19 for anti-scalp locations on
models915044, 046, 048, 050. See figure 20
for anti-scalp locations on model 915042.
There are two positions:
• Highest Position: Use to disable
anti-scalp feature.
• Lowest Position: Use for all cutting
positions.
In the lowest position the anti-scalp rollers will
touch the ground.
1. Air Lift Erosion
Area
2. Cutting Edge
Figure 18
OE0052
2
1
DO NOT Sharpen to this Pattern
Sharpen to this Pattern
DISCARD
if more
than 1/2 in.
(1.27 cm)
Figure 19
OE0038
1
1. Anti-scalp
Roller
2. Lowest Position
3. Highest
Position
2
3
1
2
3
Models915044, 046, 048, 050
