Place the model on a flat surface. The assistant stands behind the model, unfolds the parachute
and holds it so tightly that the lines are taut. The pilot gives full throttle and at the same time the
assistant releases the screen - the model starts.
4. Starting and flying the Sky Surfer 2.0
Check before flight:
1. Check if LiPo flight battery is fully charged.
Fly with with a fully charged battery only!
2. Check that your transmitter batteries are full
or the transmitter batteries are charged. Fly
with with a fully charged battery only!
3. Check the Sky Surfer 2.0 for damage and
dirt, as this can increase weight and
thus provide poor flight characteris-
tics.
4. Check the propeller for damage.
5. Check the servo functions.
6. Check the lines for damage and
proper mounting on the chassis.
They may not be twisted.
Leave he right control stick during
the launch in the middle position -
servo rod horizontal.
left
right
ON OFF
Starting procedure:
1. Note the wind di-
rection! Always start
against the wind di-
rection.
2. Turn ON transmit-
ter first and then the
model.
3. To start, hold the Sky
Surfer 2.0 at the bottom
of the chassis and move
the arm shown with a uni-
form motion from bottom to
top as shown in the fig. Do
not throw! Once the parachu-
te is fully deployed, give full
throttle on the transmitter.
Note:
The transmit-
ter is equipped with a
security function, so
the motor can not start
when switching on ac-
cidentally. To activate
the model, you need
to push the left throttle
stick to the top of the transmitter once (full
throttle) and then again all the way down
(motor off). Only after you have reached the
bottom position - for acoustic control a short
beep sounds - the receiver in the Sky Surfer
responds and you can control the model.
Note the wind direction! Al-
ways start against the wind
direction.
Rise off ground with assistant
Turn ON transmitter first and then the model.
33
Operating Instructions Sky Surfer 2.0
