16
LiPo, Lilon, LiFe, NiCd, NiMH, Pb battery charge process
The programmed data are stored in the memory and used to charge the batteries. Tapping the Enter
button initiates the charging process. The balance connector verification, the charge mode verification,
the number of cells to be charged, and the delay time setup should be finished prior to the charging
process. If the parameters are correct, tap the START button for operation.
Below picture shows the sequence of charging
Charge mode per battery type
[ AUTOMATIC ]
NiCd/NiMH : This step is an automatic charging process, first determining the number of cells and then mon-
itoing the charge current. The charger calculates the internal resistance and charge current for every period
of time, automatically adjusting the charge current to ensure the delivery of the optimal charge current to your
pack. The PEAK SENS values (NiCd=7mV/cell, NiMH=4mV/cell) are applied automatically. The CUT-TEMP values
can be programmed.
(1) Balancer port Test
After configuration, tap the battery
mark long and the balancer port
test will be performed. And then it
will be stand-by for start
This screen will be presented
if the balancer is not connect-
ed. And the Cell count could not
be changed by manual. Tap the
screen and it will be stand-by for
start.
(It will not be presented in case
of NiCd and NiMH)
(2) Charge mode and Delay time
Configure the Delay time for Charge option and operation
start. The Charge option could be picked tapping repeat-
edly. According to the batteries, the Charge options are
following.
Press the button for starting the charge
mode.
It will be available from 1 to 150 min. This is a reserved
timer for starting the Charge mode.
Charge mode selection
Delay time setup
