P5
-Reverse mode :
Green LED will be blinked twice per a
second interval.
Program mode : Blink once per a second interval
Normal mode : Blink once per a second interval
(Repetition 5times)
Reverse mode : Blink twice per a second interval
(Repetition 5times)
(5) Fail Safe Set
Press right stick switch for a second at Program mode.
Press trim button per channels and select Fail pos mode
and Hold it.
Whenever press Trim button, Setting-condition will be
transferred to Receiver.
If press right-stick switch for a second, Fail safe setting
mode will be ended.
- Indication of Fail Safe mode : RED LED will be blinked
twice per a second interval.
- Pos mode : If Trim is UP, it is a Fail safe mode, and
Green LED will be blinked twice per a second interval.
(Repetition 5times)
- Hold mode : If Trim is Down, it is a Hold mode, and
Green LED will be blinked once per a second interval.
(Repetition 5times)
Program mode (Failsafe mode): Blink twice per a
second interval
Hold mode : Blink once per a second interval (Repetition
5times)
Pos mode : Blink twice per a second interval (Repetition
5times)
How to do Stick Calibration
(1) Enter to Stick Calibration Mode
Turn On the Radio, in state of pressing left stick switch.
If enter to Mode, RED LED will blink 3 times.
Stick calibration mode : Blink 3 times per a second
interval
(2) Set Stick Calibration
Move all sticks from side to Side and back to middle
position.
After operated last stick, hold it to middle position for
3Seconds.
If Set is done, Red and Green LED will blink 3Times at
same time.
Stick calibration mode
Stick move done
Blink 3 Times per a second interval
※ after that, it is moved to Dead Range set mode
automatically.
(3) Dead range set
This is for keep Neutral position, in case of they have no
accurate Neutral value.
Dead range set about Neutral position, is set by trim
switch up and down.
It can be settable from 1 to 6 steps. ( 0, 2, 4, 6, 8, 10% )
※ in case of Throttle CH1, there is no spring, Do not set.
( only set for CH2, CH3, CH4 )
Green LED will blink depends on Neutral set steps.
For example, if you set Dead range to 6%, LED will
blink 4times per a second interval.
Dead range mode
Blink 3times per a sec interval.
Dead range set
Blinks depends of setting value (6 steps)
If set is done, press left stick button for 2 sec.
