GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved! No liability for printing errors!
10/2011
- 8 -
The rudder is controlled by control leads on two sides. The figure shows the double
rudder horn and the clevis with threaded bushing on the servo side. Insert the control
leads into the fuselage and secure them as shown with the pressed-together
bushing.
The figure shows the central rudder servo with the inserted control leads, which are
adjusted and tightened using the threaded bushings. For this purpose, glue in the
rudder horn and drill a Ø 1.6 mm hole in the servo lever arm. Place rubber grommets
on the servo, insert the hollow rivets from below, and screw in the servo. All servo
attachment elements are included with the respective servos.
The two-part elevator is controlled by two separate servos. The figure shows the left
elevator servo. Make sure that the two rudder horns are glued in exactly the same.
Note: If you do not wish to fly any extreme flight manoeuvres, you should reduce the
rudder deflection in accordance with the transmitter setting.
