GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors.
12/2011
Made in
Vietnam
10
When the glue has set hard, lay the tailplane on the saddle on the fuselage, and set it
exactly central; it must project by the same amount on both sides, and be square (at
right-angles) to the fuselage centreline.
Use a felt-tip pen to mark the outline of the fuselage on the underside of the tailplane.
Melt the covering film by running the tip of a hot soldering iron along the marked
lines, working just inside the lines. Take care not to use too powerful an iron; the heat
should be just sufficient to melt the film.
Carefully peel the covering film from the wood inside the marked lines.
The tailplane can now be glued to the fuselage using UHU coll or UHU hart. Position
the panel exactly as described at the start of this section. Pin or tape the tailplane in
place while the glue is drying, to prevent it shifting out of position.
