GRAUPNER/SJ GmbH D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors.
3/2013
-
7
-
Trim parts (22) and (23) to fit on the fuselage, and trial-fit the locating pieces (23) and
(23a). Glue the parts together, and tape them to the fuselage while the glue is drying;
take care not to glue them to the fuselage itself. Carefully trim the moulded canopy to
final size, and glue it to the canopy frame using UHU ALLESKLEBER Kraft.
Allow all the glued joints to set hard before rounding off the fuselage to the profile
shown in sections E-E and F-F, using a balsa plane and sanding block. This process
produces a good-looking, streamlined fuselage, and also saves considerable weight.
Tailplane
Lay plan sheet 1 on the building board, and cover the tailplane area with clear plastic
film to avoid the components sticking to the plan later. Assemble parts (26) to (42) as
