GRAUPNER 33506, Manual

Page: 11 / 24

11 / 24
33506_33508_33512_33516_T1V2sh
Attention
When selecting and connecting a power supply, be aware that
although the operating range of the receiver ranges from 3.6 to 8.4
V. However, practically all of the previously marketed servos, speed
controllers, gyros, etc. as well as many which are offered today have
a permissible operating voltage range of 4.8 to 6 V.
Binding
To establish a connection with the transmitter, the Graupner HoTT
receiver must first be "bound" to at least one model memory in "its"
Graupner
HoTT transmitter. This process is generally called "bind-
ing".
Binding step-by-step
1. Prepare the transmitter to be bound according to its instructions
for binding.
2. Switch the receiver power supply on.
ശ The LED of the
GR-12 HoTT
receiver remains dark.
ശ The LED of the GR-16 HoTT , GR-24 HoTT or GR-32 HoTT
receiver blinks in red with a slow rhythm.
3. Push and hold for about three seconds the SET button on the
receiver.
ശ The LED of the GR-12 HoTT receiver remains still dark.
ശ After this time has elapsed, the LED of a GR-16 HoTT , GR-24
HoTT or GR-32 HoTT flashes red and green simultaneously
for a further approx. three seconds. During this time, the
related receiver is in bind mode.
4. Start the transmitter-side binding according to the instructions of
the transmitter.
5. If the LED of the GR-12 HoTT , GR-16 HoTT , GR-24 HoTT or GR-32
HoTT receiver starts to light constantly green within approxi-
mately three seconds, the binding process has been completed
successfully.
Your transmitter/receiver combination is ready for operation.
If the LED of a
GR-12 HoTT remains dark or the LED of a GR-16
HoTT , GR-24 HoTT or GR-32 HoTT receiver still blinks red in a
slow rhythm, the "binding" was unsuccessful. Change the posi-
tions of the associated antennas and try the entire procedure
again.