GRAUPNER 23608, Installation And User Manual

Page: 17 / 24

Bedienungsanleitung XZ-R1 IFS Seite 17 Ver. 1.0
2. SETTING UP THE SATELLITE RECEIVER
2.1 – Setting up telemetry communication
Before the satellite receiver can be recognized by the Graupner IFS receiver it must be told how
to communicate. This is accomplished by putting the Graupner IFS receiver into
Telemetry
Setup mode .
To put the Graupner IFS receiver into
Telemetry Setup mode , follow the instructions below:
1. Make sure the Graupner IFS transmitter is turned off.
2. Connect the satellite to the main receiver as described during “Installation”.
3. Power up your Graupner IFS main receiver (where the satellite is connected) and
wait for the STATUS LED to begin flashing red .
4. Now press and hold the programming button on the Graupner IFS main receiver
until the STATUS LED changes from off, then to green , then to red .
5. This process will take approximately 7 seconds. This puts the Graupner IFS
receiver into “ programming mode ”.
6. Once you have entered programming mode , the STATUS LED will be solid red (the
first programming option). Each time you press and release the programming
button, the STATUS LED will change colors, indicating a different programming
function.
7. Press and release the programming button 5 times (remark: after the first push to
the button the main receiver will show a solid green STATUS LED, after the second
push a solid orange LED, after the third push a blinking red LED, after the fourth
push a blinking green LED, and after the fifth push an blinking orange LED.)
8. The STATUS LED should be flashing orange , indicating that the “ telemetry Setup
mode has been reached.
9. Now, press and hold the programming button until the STATUS LED turns off, and
then release the programming button.
10. The STATUS LED will now be green indicating that telemetry setup mode is active.
Once in this mode, the STATUS LED on the satellite receiver (and any other
telemetry devices) will be
orange .
11. If not, check the cable to make sure that it is correctly attached to the satellite
receiver and Graupner IFS receiver and repeat the process.
12. Now, press and release the programming on the satellite receiver.
13. The STATUS LED of the satellite will turn off.