32
Triton Plus - Analog Stereo Audio - User Manual
Control Panel Operation
Panel Enable
The panel will start up in a disabled state. In this state the button will be red
and all the other buttons will be disabled. When pressing the button the
panel will be enabled and the color will change to green. A status request
will also be sent to get information on active levels.
Take On/Off
The
Take On/Off
button enables or disables the
Take
button. On first start-up
the
Take
button is enabled. Later it will read the last status from the flash
memory.
Take
The
Take
buttons LED is normally off. If the
Take On/Off
button is set to on, no
commands will be sent from the panel until the
Take
button is pressed. The
last selected buttons and the
Take
button will blink, until the
Take
button is
pressed and the command is sent from the panel.
Output
An
Output
button is used for selecting an output. Selecting an output acti-
vates it, so that it is switched to the next input that is selected.
Input
An
Inpu
t button switches the active output to the selected input. If the
Take
button is enabled, the switch will not be executed until
Take
is pressed.
When switching using the
Input
button, all enabled audio- and video-levels
will be switched from the selected input to the active output.
Note
The
Input
button can also be used to select the active output. This is useful
on single bus panels. When the panel is enabled, press the
Panel Enable
button and hold it while selecting the active output by pressing an
Input
button. Then release the
Panel Enable
button. The panel will now be dis-
abled. Press the
Panel Enable
button again to enable it.
