GUIDE TO INSTALLATION AND OPERATION
10
| IPG-4901
Section 2.
The left portion of the window contains selection buttons for all of the individual panels, which become
highlighted when they are selected. The main window section (3) then displays the selected panel, all of which are
described in detail below.
Section 3.
The main section displays the panel selected in section 2. It may contain multiple tabs to access any
appropriate sub-panels.
Section 4.
The lower left corner of the window identifies the Preset currently in use or “Custom” if none is applicable.
4.2 Gateway panel
The Gateway panel provides resources for configuring and managing the gateways on the IPG-4901.
The
Gateway Status
icons at the top of the panel show the current status of all eighteen gateways on the IPG-4901:
•
Top two rows:
the nine OUT-from-fabric gateways
•
Bottom two rows:
the nine IN-to-fabric gateways
Click the
Gateway Table
button to open the pop-up
Gateway Config
window
4.2.1 Gateway Availability
Although the IPG-4901 has 18 gateways (9 IN and 9 OUT), not all are always available, due to bandwidth and
configuration requirements. See
Section 5.3.1 - Network Config Panel - Settings tab
ETH2
Available Gateways
Notes
Enable
Operation Mode
OUT
IN
OFF
N/A
1-5
10-14
Only ETH1 gateways in use.
ON
Redundancy
1-5
10-14
Each gateway uses both ETH1 and ETH2
with identical stream addresses.
Aggregation
All (1-9)
All (10-18)
ETH1 and ETH2 gateways in use.
Figure 4-2
Gateway panel – upper portion
