GRASS VALLEY DMC 1000, User Manual

Page: 91 / 176

DMC 1000 Digital Media Camcorder User’s Guide (v4.0) 91
Chapter 6 - Audio setup
6.7.4 Call
Either user button can be assigned to the intercom Call function. When the user button is
pressed, a signal is sent to a connected OCP 400 control panel, calling for attention. The
CALL
button on the OCP 400 lights green.
The ND/RE indicator in the viewfinder also lights when a call signal is sent or received.
☞
Note
☞
Note
This function is only available when the
SYSTEM > HARDWARE > NETWORK > REMOTE REC
item
is turned off.
6.7.5 Return channels
The return intercom channels (Engineering and Production return) can be output to the
embedded SDI audio channels, depending on your transmission configuration:
1. Go to the
AUDIO > OUTPUTS > SDI OUT
menu.
2. Tap the button of the SDI channel you want to use for the Engineering return channel,
3. Select Eng-Ret,
4. Tap the button of the SDI channel you want to use for the Production return channel,
5. Select Prod-Ret.
6.7.6 Incoming channels
Set up the built-in audio mixer to combine the incoming intercom channels to your personal
preference:
1. Go to the
AUDIO > SYSTEM > MIXER
menu.
2. Tap each
SOURCE
buttons and choose the following settings:
– For
SOURCE1
, select Eng (incoming Engineering intercom channel),
– For
SOURCE2
, select Prod (incoming Production intercom channel),
– For
SOURCE3
, select Program (incoming Program intercom channel),