GRASS VALLEY 8995DNC -, Instruction Manual

Page: 94 / 140

94 8995UPC/DNC/UDX — Instruction Manual
Configuration
Figure 58. Choose File Screen
4. Select a file to load and then press
Open
to bring the file into the filename
field.
5. Press the
Load
button in the Load From... web page ( Figure 57 on
page 93 ) to load the file to the module.
Use the two recall buttons at the bottom of the web page to do the fol-
lowing:
•
Set Factory Defaults
– select the
Set Factory Defaults
button to recall factory
settings to the module. Defaults for all module parameters are listed in
Table 13 on page 111 .
•
Set Factory Names
– select the
Set Factory Names
button to recall factory
signal names to the module. Defaults for all signal names are displayed
on the I/O Config web page shown in
Figure 24 on page 47 .
Note As mentioned in a previous note, recalling default factory settings and names
must be done after any software update. This writes over your current con-
figuration so follow the instructions for saving your configuration before
updating software.