GRASS VALLEY 8995DNC -, Instruction Manual, Page: 48 / 140

48 8995UPC/DNC/UDX — Instruction Manual
Configuration
System Config Web Page
Use
this
link
Use the System Config web page ( Figure 26 on page 49 ) to set the system
configuration parameters for the module. For a complete list of module
parameters, refer to the summary table in the
Summary of
8995UDX/UPC/DNC Configuration Functions on page 111 .
Test Output
Enable the colorbars test signal on the module output with the
Enabled
button.
Video I/O Configuration
The following controls are available in this section:
•
Ref Input
– displays the reference input standard connected to the
Genlock Loop through BNCs on the rear module. Refer to Table 6 on
page 51 for a listing of output standards and compatible frame refer-
ences.
•
Input Standard
– choose the desired input standard from the pulldown
choices or use the
Auto
selection. The signal input type selected will be
reported in the web page header as the Input Video Standard. When
Auto
is selected, the input signal type detected on BNC J9 will be
reported.
• Output Standard – choose the desired input standard from the pulldown
choices. This will determine what action the module will perform, up
conversion, down conversion, or cross conversion.
Refer to Signal Conversion on page 27 for an explanation of the conversion
types and valid and invalid conditions.
When a new configuration has been selected with the Input and Output
Standard pulldowns, such as a up conversion operation shown in
Figure 25 , a message will appear indicating
Changes Pending: Click Apply Set-
tings button to commit changes .
Figure 25. Changes Pending Message