GRASS VALLEY 8995DNC -, Instruction Manual

Page: 15 / 140

8995UPC/DNC/UDX — Instruction Manual 15
Installation
Rear Module Installation
To install the rear module, refer to Figure 2 and the instructions below:
1.
To remove a blank rear adapter cover (or a rear module already
present), manually loosen the two screws holding each retainer clip on
the rear adapter cover or rear module to the frame with the retainer clip
tool provided inside the front cover of the frame (newer model frames
only) or a 2 mm (5/64”) hex screwdriver. Do not remove the screws.
Note To remove a rear module already installed, follow the same steps. It is helpful
to first remove the front module so the rear can be pulled out more easily.
1. After loosening the retainer clip screws, pull up on each retainer and
completely remove it, leaving the screws in place.
2. Remove the blank rear adapter cover by inserting needlenose pliers
into the slots in the blank cover and pulling it off.
3. Insert the rear module into the empty slot, guiding it carefully.
4.
Replace each retainer clip over the two screws on both sides of the
module and push down to seat the retainer clip.
5.
Tighten the two screws on each retainer clip just until they come into
contract with the retainer clip then tighten about a 1/4 turn more. The
retainer clips should not bend or be bowed. The rear retainer clip screw
torque specification is 4-5 inch-lb/0.45-0.6Nm).
Note All unused rear slots in a GeckoFlex frame should have a blank rear adapter
cover installed.
Figure 2. Installing Rear Module (751- Version Frame)
8444_23
r
0
U s e r etai n e r clip o r
n eedle n o s e plie rs
to p u ll o u t bla n k afte r
r emovi n g r etai n e r clip s