GRAPHTEC CE5000-120, Service Manual

Page: 62 / 128

CE5000-UM-251-9370 6-26
6. DISASSEMBLY AND REASSEMBLY
6.2.12 How to Replace the X-motor
The CE5000-40 and the CE5000-60 models use the same X-motor.
The CE5000-120/120AP model uses a different X-motor from the CE5000-40 and the CE5000-60 models.
How to detach the X-motor
(1) Detach the left side cover (see Subsection 6.1.2).
(2) Detach the front guide (see Subsection 6.1.5 or 6.1.6).
(2) Detach the rear guide (see Subsection 6.1.7).
(3) Loosen the two M3L4WP set screws holding the X-motor pulley then detach the X-motor pulley.
M3L4WP set screw
M3L6 binding head screw
(4) Remove the three M3L6 binding head screws holding the X-motor then detach the X-motor.
(5) Disconnect the X-motor cable from its connector(s) on the main board.
CE5000-40/60: ............. Disconnect the encoder cable from the motor and disconnect the motor cable
from the relay connector.
CE5000-120/120AP: .... Disconnect the cables from connector J1102 and J1104 on the X-motor relay
board.
(6) Remove the wiring harness tie-wrap holding the X-motor harness and detach the X-motor.