GRANDVIEW CRYSTAL SCREEN CO.LTD.
NO 43.S,Guomao Ave.Hualong,Panyu,Guangzhou,GuangDong.P.R.C
After sales service Tel:020-84899499
Note :
When connecting to Rs232 or Rs485, if there is any motion that
cannot be controlled by the screen, please adjust the screen,
please adjust the two control lines;
Wiring loop resistance is less than 20
Ω;
Do
not
run
in
parallel
with
strong
interference
sources
;
232
port
setting
:
2400
,
n
,
8
,
1
A
data
string
should
be
sent
twice
consecutively
.
Large Stage MBII Installation Manual
Model:LS-MBFxxxII(xGxx)
Intelligent RF control with external motor
Reminders
Thank you for purchasing Grandview products. Please read the instructions carefully before
installation and use, and collect it after reading for future use;
This product must be installed by a qualified professional after the feasibility assessment of
the environment, electricity, structure, etc.;
Do not disassemble or replace the original spare parts at will: If there is any fault, please
contact the after-sales service department.
Wireless
control :
Press the up button, the screen will rise.
Press the
stop
button, the screen
stop
.
Press the
down
button, the screen
down
.
UP
DOWN
Wireless
transmitter
Positioning
Settings
Key
Code pairing / deleting (factory pairing is successful):
Pay attention:
Long press the cycle button for 3 seconds, the screen is jogged once to enter the code-matching state; within 10 seconds, the
remote control up and stop buttons are also pressed, and the screen is jogged again to complete the code-matching; the code
deletion is the same as the code-matching operation, odd times The operation is code pairing; even code deletion.
To confirm the accuracy and security of the screen position, It is necessary to control the screen up and down after
adjusting every half turn of the button, Check if the position is moving correctly;
Be careful when adjusting the screen retracted height. Excessive adjustment will cause the lower rod to snap into
the casing and cause serious damage to the screen or the lower rod falling;
Be careful when adjusting the unfolding height of the screen. Always keep the fabric 1.5 turns or more around the
tube to ensure that the fabric does not fall;
Electrical parameters: Voltage Ac220 ~ 230V 50 /60Hz , Current 1.5A;
Wireless remote control (F): voltage 3V, using battery CR2032X2, transmission frequency; 868MHz, effective control
distance of about 15 meters;
Intelligent electronic stroke positioning (this product can set the up and down stroke of the fabric through the remote control)
Operation method:
Adjusting method of fabric retracting (upper limit) and upfolding (lower limit):
Upward stroke setting: Positioning setting key (light on)
→
Up key → Up and down remote control to the desired position →
Stop → Positioning setting key (light off) → Upward travel record success
If it is really necessary to adjust the limit height due to the installation environment or site limitation, you can use the motor
positioning adjustment key to rotate the knob on the motor limiter; the limiter adjustment knob is located in the 12 round hole
next to the power cord outlet.
Downstroke setting: Positioning setting key (light on)
→
Down arrow key → Remote control up and down to the desired position
→ Stop → Positioning setting key (light off) → Downstroke recorded successfully
Adjustment
hole
Power cable
Yellow button
Retracted height(lower limit)
Clockwise Down
Counterclockwise Up
Motor
White button
Unfolding height (upper limit)
Counterclockwise Down
Clockwise Up
