Green label adjustment hole-the door shuttered
Yellow label adjustment hole-the door shuttered
as it closed
（
clockwise
）
as it closed
（
clockwise
）
Figure 9
FAQ
The cause of the trouble
The solution
Trouble
Line problem
Contact factory or distributor
Motor heating protection
Layer board
Close the door shake
Open the door shake
Wait for motor cooling
The elevator is fully
installed but not
working properly
Remote control
doesn't respond
Positioning confusion
Bad reception/The signal block
Restart the lift power supply
Positive and negative electrode of generator battery is
installed backward or the battery power is insufficient
The design of this product can be used without failure for many years, many problems are caused by simple things.
If something goes wrong, check out our simple fix list.If the problem continues, please contact the authorized dealer
or call the after-sales service number: 020-84899499-509
Check whether the battery is installed backward according to the
instruction. If the fault is not removed, please replace the battery
Refer to picture 9 for a slight clockwise half turn
Refer to the yellow mark in picture 9 and turn it clockwise slightly for half a turn
Connect the power cord according to the instruction
The power cord is not properly connected
The adjustment screw becomes loose during transportation
The adjustment screw becomes loose during transportation
Left and right corresponding door panel adjustment
indication diagram:
