FIRMWARE VERSION 1.0.5.2 GXP1160/GXP1165 USER MANUAL
Page 38 of 59
SIP 401 Unauthorized response. The PBX will need resend the SIP
INVITE request with authentication credentials. The default setting is
"No".
Preferred Vocoder
7 different vocoder types are supported on the phone, including G.711
U-law (PCMU), G.711 A-law (PCMA), G.723.1, G.729A/B, G.722 (wide
band), iLBC and G72-32. Users can configure vocoders in a preference
list that is included with the same preference order in SDP message.
SRTP Mode
Enables the SRTP mode based on your selection. The default setting is
"Disabled".
Symmetric RTP
Defines whether symmetric RTP is supported or not. The default setting
is "No".
Silence Suppression
Controls the silence suppression/VAD feature of the audio codec G.723
and G.729. If set to "Yes", when silence is detected, a small quantity of
VAD packets (instead of audio packets) will be sent during the period of
no talking. If set to "No", this feature is disabled. The default setting is
"No".
Voice Frames Per TX
Configures the number of voice frames transmitted per packet. When
configuring this, it should be noted that the "ptime" value for the SDP will
change with different configurations here. This value is related to the
codec used and the actual frames transmitted during the in payload call.
For end users, it is recommended to use the default setting, as incorrect
settings may influence the audio quality.
No Key Entry Timeout (s)
Defines the timeout (in seconds) for no key entry. If no key is pressed
after the timeout, the digits will be sent out. The default value is 4
seconds.
Use # as Dial Key
Allows users to configure the "#" key as the "Send" key. If set to "Yes",
the "#" key will immediately dial out the input digits. In this case, this key
is essentially equivalent to the "Send" key. If set to "No", the "#" key is
included as part of the dialing string.
G723 Rate
Selects encoding rate for G723 codec. The default value is 5.3kbps.
G.726-32 Packing Mode
Selects "ITU" or "IETF" for G726-32 packing mode.
iLBC Frame Size
Selects iLBC packet frame size. The default value is 30ms.
iLBC Payload Type
Specifies iLBC Payload type. The default value is 97. The valid range is
between 96 and 127.
Jitter Buffer Type
Selects either Fixed or Adaptive based on network conditions. The
default setting is "Adaptive".
Jitter Buffer Length
Selects Low, Medium, or High based on network conditions. The default
