Grandstream Networks 7898908277180, User Manual

Page: 13 / 40

Grandstream Networks, Inc.
GXW40XX User Manual
Page 13 of 40
Firmware 1.0.5.10 Last Updated: 01/2012
Enter MAC address to restore factory default setting
(See
Restore Factory Default Setting
section)
“Invalid Entry” Automatically returns to Main Menu
Five Success Tips when using the Voice Prompt
1. “*” shifts down to the next menu option
2. “#” returns to the main menu
3. “9” functions as the ENTER key in many cases to confirm an option
4. All entered digit sequences have known lengths - 2 digits for menu option an d 12 digits for IP
address. For IP address, add
0
before the digits if the digits are less than 3 (i.e. - 192.168.0.26
should be key in like 192168
00
0
0
26. No decimal is needed).
5. Key entry can not be deleted but the phone may prompt error once it is detected
P
LACING A
P
HONE
C
ALL
P
HONE OR
E
XTENSION
N
UMBERS
1. Dial the number directly and wait for 4 seconds (To change the default value, modify the following
setting - “No Key Entry Timeout”)
or
2. Dial the number directly and press # (Use # as dial key” must be configured in web configuration).
Examples:
1. Dial a nu mber (e.g. (626 ) 666-7890), first ente r the prefix numb er (usually 1+ or inte rnational
code) followed by the pho ne number. Press # o r wait for 4 se conds. Che ck with you r VoIP
service provider for further details on prefix numbers.
D
IRECT
IP C
ALLS
Direct IP calling allows two parties, that is, a FXS Port with an analog phone and another VoIP Device, to
talk to each other in an ad hoc fashion without a SIP proxy.
Elements necessary to completing a Direct IP Call:
1. Both GXW40XX and other VoIP Device, have public IP addresses, or
2. Both GXW40XX and other VoIP Device are on the same LAN using private IP addresses, or
3. Both GXW40XX and other VoIP Device can be connected through a router using public or private
IP addresses (with necessary port forwarding or DMZ).
GXW40XX supports two ways to make Direct IP Calling:
Using IVR
1. Pick up the analog phone then access the voice menu prompt by dial “
***
”
2. Dial “
47
” to access the direct IP call menu
3. Enter the IP address using format ex.
192*168*0*160
after the dial tone.
Using Star Code
1. Pick up the analog phone then dial “
*47
”
2. Enter the target IP address using same format as above.
Note:
NO
dial tone will be played between step 1 and 2.
Destination ports can be specified by using “
*
” (encoding for “:”) followed by the port number.