39
4.
Push in the control knob as far as it will go and turn it counterclockwise to
HIGH. At the same time push the spark ignition button until the burner is lit.
5.
Continue holding the burner control knob all the way for about twenty (20)
seconds after ignition. This will heat the thermocouple is designed to cut off
the gas supply to the burner if the flame should accidently be extinguished.
6.
If the electromagnetic ignition fails turn the burner OFF and apply a lit
match before turning it back to the HIGH position.
7.
You should now be able to set the flame by turning the control knob (low=1,
high=6).
8.
To turn off the burner turn the control knob to OFF.
9.
You must shut off both the solenoid and the manual gas cylinder valves
whenever the vessel is unattended or if there is an emergency.
Lighting the Oven
1.
Light the oven burner using the procedure described in instructions
above.
2.
Close the oven door carefully to ensure that the oven burner will not be
extinguished. You can also use a lighter or match. It may take a few
seconds the first time to light due to the air in the line between the
propane tank and the appliance. You might need to hold knob in for a
few seconds while the thermocouple warms up.
When finished turn the LP GAS switch off and turn the GAS STOVE circuit
breaker on the DC Power Panel to OFF.
If leaving the boat, it is a good idea to turn off the gas at the tank.
Summary of Contents for Latis
Page 51: ...51 ...
