- 3 -
765041559
Rev. 002
The introduction.
To Compact 6610 range is used tree different program variants. There is directly access to the menus on the
front of our cabinet, which was a great help for the service men and also for the workers in the factory here in
Vojens.
Make sure the appliance is switched off at the socket before service is performed on electrical
parts. It is not sufficient to switch off the cabinet by the START/STOP key as there will still be
voltage to some electrical parts of the cabinet..
Software version and program variant in start-up sequence
When the cabinet switches ON, the controller shows the software version and program variant.
The version number glows in 2 sec. followed by name on the program variant until the controller is finished
with the start-up sequence. The program variant is like the example here below.
In the example above software ver. 2.1 and program variant M2+ is presented.
Cabinets with compressor (HAV) is given by the symbol ” ”. The
symbol should look like a “+” which means including compressor.
Cabinets without compressor (FAV) is given by the symbol ” ”.
The “-“ symbol means “Compressor not included”.
Because program variants like K and M
is difficult to present in a 7-segment
display, the symbols below is used
instead:
H
(Refrigerator).
n
(Extended temperature range).
Other program variants name:
F
(freeze).
B
(Counter).
V
(Varm/hot/swallow cabinets)*.
P
(Process cabinets).
E
(Extreme low temperature).
* Complete new variant
Earlier Software versions
From 127 to 138: version
2.0
From 138 to 122: version
2.1
From 122: version
3.0
Defrosting
The defrosting cycle runs 4 times each day. There exist no lamps for indication of a running defrosting cycle.
If the cabinet is operating under severe load (frequent door opening and frequent replenishment) manual
defrosting can become necessary. The manually defrosting can be carried through by pushing and key
in more than 3 sec. The cabinet starts a defrosting cycle.
With the same to keys, a defrosting cycle can be stopped before end time.
The next defrost will occur 6 hours later.
Like other standard cabinets, the defrosting cycle is also controlled by time. This means that if the
temperature hasn’t reached the stop temperature, the timer function will stop the defrosting cycle.
