FR566GH-INS-LAB-RevA10
3
9. Place the cable labeled
HEAT A
inside the Junction Box. Replace the Junction Box cover; re-
place the two hex head screws that secure the Junction Box cover. Use a
1
/
4
" hex wrench to
secure the screws.
10. Remove the tape holding the back flap. Lower the flap and seal the compartment.
11. The Heat and Massage Unit is now ready for operation; instructions for use follow.
CAUTION: Before rolling the recliner, ensure the power cord is unplugged from the AC
outlet.
Heat and Massage Unit Operation Instructions
1. Plug the Power Supply Cord into any grounded
outlet.
2. The Heat and Massage Unit is operated using
the Single Multi-Position Selector Switch located
on the Right Side of the Recliner underneath the
Armrest. The Heat and Massage Functions can
be operated independently. The Selector Switch
faceplate is shown at right.
3. Press the Selector Switch UP to activate the
HEAT FUNCTION.
4. Press the Selector Switch DOWN to activate the
MASSAGE FUNCTION.
5. The Selector Switch has THREE HEAT SETTINGS and FOUR MASSAGE SETTINGS as follows:
6. HEAT FUNCTIONS:
a. Press Selector Switch UP for Setting 1: High Heat, 106°F (41°C), brightest LED
b. Press Selector Switch UP AGAIN for Setting 2: Medium Heat, 104°F (40°C), bright LED
c. Press Selector Switch UP AGAIN for Setting 3: Low Heat, 100°F (37°C), dim LED
d. Press Selector Switch UP AGAIN: Heat Function shuts off.
e. There is a small Red Indicator Light, which illuminates only during the Heat Function, in the
Selector Switch. The light's brightness is determined by the Heat Level being used:
Brightest = High Heat; Dimmest = Low Heat.
7. MASSAGE FUNCTIONS:
a. Press Selector Switch DOWN for Setting 1: Gentle Lower Back Massage
b. Press Selector Switch DOWN AGAIN for Setting 2: Firm Lower Back Massage
c. Press Selector Switch DOWN AGAIN for Setting 3: Gentle Upper and Lower Back Massage
d. Press Selector Switch DOWN AGAIN for Setting 4: Firm Upper and Lower Back Massage
e. Press Selector Switch DOWN AGAIN: Massage Function Shuts Off.
8. The Heat and Massage Unit automatically shuts off at the following times:
a. HEAT FUNCTION: After One Hour of Continuous Use at the Same Level
b. MASSAGE FUNCTION: After Fifteen Minutes of Continuous Use at the Same Level
c. To restart the Heat and Massage Unit, follow the instructions above.
If you have any questions about the setup and/or operation of the Heat and Massage Unit, please
call the Graham-Field Technical Support Group at 800-347-5678.
Press Up
For Heat
Press Down
For Massage
OFF
1 GENTLE
LOWER BACK
2 FIRM
LOWER BACK
3 GENTLE
UPPER & LOWER
BACK
4 FIRM
UPPER & LOWER
BACK
OFF
3
LOW
2
MEDIUM
1
HIGH
