Graham Field JB0112-090, User Manual

Page: 8 / 35

JB0112-090-INS-LAB-RevA18 8
SETUP
Info: Before initial operation, clean the nebulizer cup assembly
following the instructions given in MAINTENANCE/Cleaning
the Nebulizer Cup.
WARNING: Ensure that the nebulizer compressor is
unplugged during setup.
1. Before each use, inspect the compressor and nebulizer cup
assembly for damage or wear; replace as needed.
2. Place the compressor on a table or other flat stable surface (not on
the floor), in an area that is clean and dust-free. Be sure you can
easily reach the controls when seated.
3. Open the nebulizer medication cup: Twist the cap counter-
clockwise until it stops, then lift cap off.
4. Pour the prescribed medication into the nebulizer medication
cup. Do not fill with more than 8 ml per treatment.
5. Install cap on cup. Turn clockwise to
tighten.
6. If using the mouthpiece for treatment,
proceed to step 7. If using a mask, install
the bottom part of the mask directly onto
the top of the nebulizer medication cup
cap as shown at right. Proceed to step 8.
7. Install mouthpiece onto top of nebulizer
medication cup cap.
install mask
on cap
mask
cap
install cap
on cup
cap
cup
install
mouthpiece
on cap
mouthpiece
cup