M
A I N T E N A N C E A N D
S
E R V I C E
6–2
Finish/Waxing
Gelcoat can lose its gloss due to constant exposure to the natural environment and pollutants.
It will require special attention to restore the original gloss and color. See a local dealer for
advice on wax for your boating region. The wax film will seal the pores as well as enhance the
looks of your boat.
DO NOT wax surfaces that may be walked on; they will become
slippery.
While waxing your boat, inspect the surface for any damage. Have the damage
corrected as soon as possible.
Gelcoat will age or dull naturally. Discolorations are shallow in depth. Factors that will affect
the rate of discoloration are: the sun, pollution, old wax accumulation, and the salt content of
water. Polishing compound (fine abrasive) or rubbing compound (coarse abrasive) is
recommended for use on fiberglass finishes to remove scratches and stains or restore severely
weathered surfaces. These products can be applied by hand or mechanical means. The process
below will help restore fiberglass finishes:
• Clean the affected area with a good detergent.
• Remove stubborn stains or discoloration by gently wet sanding the affected areas with 600 grit
“wet or dry” sandpaper.
ALWAYS SAND IN ONE DIRECTION.
Use plenty of water and
sand curves in the same direction. Dry the area to make sure all the discoloration has been
removed. Repeat this process if necessary.
• Buff using a polishing compound suitable for fiberglass, an electric buffer (1750-1800 RPM),
and an 8-inch lamb’s wool pad.
• When buffing is complete, wash away compound with clear water and dry the area.
• Once the area is clean it may be waxed. This will enhance the gloss while providing a seal to
retard staining or soil accumulation.
C A U T I O N
Keep buffer moving. Do not allow it to rest in one spot. Heat build up will quickly distort the
surface.
C A U T I O N
Compounding too often or excessive compounding can wear away the gelcoat.
!
!