3.6
Connect PC and Peripherals
3.7
Mount the Jet
Before attaching the jet, make sure that the controller Power switch and Fluid Air switch
are both OFF.
Locate the quick-release jet mount. The jet mount is installed
1.
at the factory with the bottom of the jet mount sitting flush
with the bottom of the Z mounting plate.
Determine the correct jet mount position. For proper
2.
placement, lines are notched into the Z head at 3 mm
intervals, as shown in Figure 8.
The flush mount position is for standard flat nozzles.
Align the jet mount bottom with the bottom of the
Z head, as shown in Figure 9 (left).
For 3 mm nozzles, align the jet mount bottom with the
first line (3 mm up), as shown in Figure 9 (center).
For 6 mmm nozzles, align the jet mount bottom with the
second line (6 mm up), as shown in Figure 9 (right).
Use a 3 mm wrench to tighten the four jet mount screws.
3.
Insert the bottom of the dovetail bracket into the middle slot
4.
of the jet mount, as shown in Figure 11. Push down firmly.
Tighten the jet mount screw, as shown in Figure 11.
5.
WIRELESS ADAPTOR FOR
KEYBOARD AND MOUSE
CAMERA FROM ROBOT
YELLOW USB PORT (10)
TO CONTROLLER RS-232 (6)
TO ROBOT RS-232 (7)
TO MONITOR (9)
Figure 7: PC Front and Rear Connections
Figure 9: Install Jet Mount Flush for Flat Nozzles;
Adjust Jet Mount Upward for 3 mm or 6 mm Nozzles
Figure 8: Notched
Lines at 3 mm
Intervals
Figure 11:
Tighten the
Mounting Screw
Figure 11: Slide
Jet Into Mount
(Flush Position
Shown)
3A5913B
UniXact Automated Jet Dispense System Installation
Page 11 of 18
