Carbide Runner Replacement on Smart Die II (300TC/ProMelt)
3A1320L
23
Carbide Runner Replacement on Smart Die II
(300TC/ProMelt)
(1 on each side)
1. Remove screed box.
2. Use allen wrench to loosen and remove upper pivot
bolt (511) to free yoke (502).
3. Turn unit upside-down and use an allen wrench to
remove four screws (513) and plate, die runner
(504).
Installation
1. Apply grease to groove where carbide runner sits.
2. Replace plate, die runner (504) with new plate, die
runner. See
Parts
manual 3A1321.
3. While applying pressure to shear bar (506) directly
over support bar (509), use allen wrench to replace
and tighten four screws (513). There should be no
gap between the shear bar and support bar when
applying pressure.
4. Use allen wrench to replace and tighten pivot bolt
(511) on yoke (502).
5. Install screed box.
NOTICE
Carbide runners need to be replaced one side at a
time. If both runners are removed, adjustment will be
lost and screed box will need to be reassembled by a
Graco approved technician.
ti16839a
ThermoLazer 300TC/ProMelt shown
ti16843a
ti16845a
ti16845a
ti17068a
ti16843a
ti16846a
ThermoLazer 300TC/ProMelt shown
