Setup
309832D
11
Connecting hose
WARNING
To avoid accidental system pressurization or
electrical shock, disconnect power cord and turn
the on/off switch to OFF. See
Warnings
, page 3.
WARNING
To prevent hose damage, do not flex hose when
cold. When hot, the hoses have a minimum bend
diameter of 16 in. (40.64 cm).
115 VAC tanks can support up to two 16 ft (4.8
m) of total hose. 230 VAC tanks can support up
to two 24 ft (7.3 m) of total hose. Read
Warn-
ings
, page 3.
WARNING
Wait until equipment/fluid has cooled completely.
See
Warnings
, page 3.
1.
Raise or tilt the melt unit backward to access the
fluid outlet fittings.
2.
Connect hose (J) to fluid outlet fitting (P). Tighten
with 11/16 in (mm) opened end wrench.
To prevent leakage, make sure hose is seated
securely on inlet fitting.
To insure proper seating of threads, make sure inlet
threads are clean. See
Troubleshooting
, page 20.
3.
Connect hose electrical connector (K) to hose elec-
trical receptacle (S). Make sure pins align properly.
4.
Screw bayonet ring of the plug onto the receptacle.
To connect second hose, repeat steps 1 through 4.
K
J
S
P