Setup
6
3A6746B
Setup
Connect Gun to Sprayer
1. Attach material hose to sprayer fluid outlet. Attach
air hose to air compressor.
2. Connect signal wire, then air hose and material
hose, tightening securely.
NOTE:
When disconnecting signal wire, press and slide
down the red tab on the connector.
Install Nozzle
1. If equipment has recently been operated,
2. For a round pattern, install round nozzle (5) and
tighten threaded retaining ring (3) as shown in Fig 1.
3. For a flat pattern, remove retaining ring (3). Place
adapter housing (4) over round nozzle (5) and
secure with threaded retaining ring (3). Install disk
(2) and secure with retaining nut (1). See Fig 2.
NOTE:
See sprayer Operation manual for
instructions on how to start and prime sprayer.
