Graco SoundSleep, Owner'S Manual

Page: 4 / 4

SETTING UP THE MONITOR
1. Check that both Nursery Unit and Parent’s Unit are set to the same channel.
2. Place the Nursery Unit within 10 feet (2-3 meters) of your baby. Plug an AC adapter
into the jack on the side of the Nursery Unit. Plug it into a working 120 volt AC outlet.
3. Aim the Nursery Unit toward your baby. Check that there are no walls or large
objects that could block sound transmission.
4. Turn on the Nursery Unit using the ON/OFF switch on the left side. The red power
light should come on.
5. Install a 9 volt battery into the Parent’s Unit, or plug it into a working 120 volt AC
outlet using the other AC adapter.
6. Turn on the Parent’s Unit using the volume control dial on the right side. The red
power light should come on.
TESTING THE UNITS
It is VERY IMPORTANT to test the system when first set up, and at regular times
thereafter. Test the units any time they may have been damaged or have not been
used for a long time.
1. If two adults are present, have one take the Parent’s Unit to different locations,
trying various volume settings, while the other speaks into the Nursery Unit.
2. If only one adult is available, place a ticking clock, radio, or other sound-producing
device near the Nursery Unit to test it.
3. When testing, keep the level of your child’s sounds in mind, and adjust the
volume accordingly.
4. If there is sound interference, switch both the Nursery Unit and the Parent’s Unit
to the other channel setting.
System Setup
This monitor operates on one or more of the following frequencies: 49.825 Mhz, 49.845 Mhz, 49.870 Mhz, 49.890 Mhz.
Maximum signal strength is 10 millivolts/meter at 3 meters.
NOTE : As with all radio frequency devices, transmission range and
reception may vary. Your Nursery Monitor uses public airwaves, so it is
possible for conversations near the Nursery Unit to be broadcast to other
nursery monitors, radios, cordless phones or scanners outside your home.
For your privacy, always turn off the Nursery Unit when not in use.
Solving Problems
Most problems have a simple solution. First, check that:
!
Power is turned ON for both units
!
Both units are plugged in (or battery is fresh in Parent’s Unit)
!
Electrical outlet works
!
Units are set to same channel
!
Volume is turned up on Parent’s Unit
!
Parent’s Unit is in range of the Nursery Unit
If necessary, try the following ideas:
NO SOUND:
Battery dead or weak—replace or use AC adapter.
Channel settings do not match—set both units to same channel.
AC adapter not properly connected—check the connections.
Nursery Unit covered or blocked—remove the obstruction.
WEAK SOUND:
Parent’s Unit too far from Nursery Unit—move closer.
Large objects blocking the signal—try repositioning Nursery Unit.
Check that antennas are vertical and are not touched by other objects.
Volume setting too low—turn it up.
STATIC:
Interference from other electrical equipment—eliminate cause of static
(TVs, mixers, computers, fans, fluorescent lights, light dimmers, etc.)
Parent’s Unit too far from Nursery Unit—move them closer.
Channel settings do not match—set both units to same channel.
Try other channel on both Parent’s Unit and Nursery unit.
SHRILL NOISE (FEEDBACK):
Nursery Unit and Parent’s Unit too close together—move them farther apart.
Volume set too high—lower the volume.
If you cannot solve the problem, please contact our
Customer Service Department at 1-800-345-4109.
Do not attempt to modify the unit. Any modifications to the transmitter
and/or receiver can void the operator’s authority to operate the equipment.
7
902-4-00
8