![background image](http://html1.mh-extra.com/html/graco/sdl23-series/sdl23-series_instructions-manual_2253105026.webp)
Repair
26
3A8626C
8. Lay the hose reel on its side to easily access the
guide arm (30) and pedestal (24).
9. Remove the long bolt (18) and washers (15 and 17)
10. Remove the snap ring (5e) (F
. 22).
11. Completely remove, as one piece, the guide arm
(30) and pedestal base (24) and set it aside for
re-installation on the new spool.
NOTE: These parts do not have to be disassembled.
NOTE: Check that the washer (5j) is not adhering to the
inside of the pedestal base (24). Discard the washer (5j)
with the old spool. A new washer (5j) is installed on the
new spool (5) and is part of the new spool (5) assembly.
12. Discard the old spool.
13. Place the new spool (5) on its side on a work bench,
with the flat side of the spool facing downward and
the ratchet side facing upward, see F
. 22.
14. Position the guide arm (30) and pedestal base (24)
assembly over the spool. Adjust, as needed, to
align the parts.
NOTE: Re-attaching the guide arm (30) and pedestal
base (24) assembly is easier when the spool (5) is
supported and level. Placing 1 in. (25 mm) scrap wood
blocks under the spool, as shown in F
. 22, supports it
during installation of the arm.
15. Replace with a new snap ring (5e).
16. Install the new swivel assembly in the spool. See
, page 38 for determining the correct Swivel
Replacement Kit.
17. Install washers (15 and 17) and the long bolt (18),
but do not tighten the bolt.
18. Turn the spool over.
19. Place the guide arm (30) and pedestal assembly
(29) over the swivel assembly and spool (5).
NOTE: For the hose reel to operate correctly, the
alignment of the swivel to the key hole in the pedestal
must be correct. See F
. 23 (a) for the proper
alignment needed.
NOTE: XNX models do not have a guide arm.
20. Install large nut (11) and tighten (torque 85 - 105
ft-lb/115.2 - 142.4 N•m) (F
F
IG
. 21
F
IG
. 22
27
11
30
29
27
26
24
5
17
15
18
30
16
24
5e
5j
F
IG
. 23
a