![background image](http://html.mh-extra.com/html/graco/reactor-3-e-20-pro/reactor-3-e-20-pro_operation_2250953039.webp)
Spray
Spray
Spray
1. Engage the gun piston safety lock and close
gun fluid inlet valves A and B.
Fusion
Fusion
Fusion
Probler
Probler
Probler
2. Attach the gun fluid manifold. Connect the
gun air line. Open the air line valve.
3. Adjust the gun air regulator to desired gun
air pressure. Do not exceed the maximum
rated air pressure. See your gun manual,
.
4. Set the pressure relief/spray valves (SA, SB)
to spray
.
WWLL EE
5. Verify the heat zones are on and
temperatures are on target.
6. Open the fluid inlet valve located at each
pump inlet.
7. Tap the Pump
Pump
Pump Mode
Mode
Mode button
.
8. Select Spray
Spray
Spray mode from the drop down
menu.
9. If
If
If using
using
using pneumatic
pneumatic
pneumatic transfer
transfer
transfer pumps,
pumps,
pumps, turn on
air to the transfer pumps. See your pump
manual,
10. Tap
to turn on the motor.
NOTE:
NOTE:
NOTE: Electric transfer pumps will
automatically turn on with the motor.
11. Check the fluid pressure gauges (GA, GB)
to ensure proper pressure balance. If
imbalanced, reduce pressure of higher
component by slightly turning the pressure
relief/spray valve for that component toward
pressure relief/circulation
until the
gauges show balanced pressures.
WWLL EE
S
A
S
B
3A8500E
39