![background image](http://html.mh-extra.com/html/graco/reactor-3-e-20-elite/reactor-3-e-20-elite_operation_2250952039.webp)
Calibration
Calibration
Calibration
Calibrate
Calibrate
Calibrate the
the
the Heated
Heated
Heated Hose
Hose
Hose
NOTICE
NOTICE
NOTICE
To prevent damage to the heated hose, a hose
calibration is required if any of the following
conditions are true:
• The hose has never been calibrated before.
• A section of hose has been replaced.
• A section of hose has been added.
• A section of hose has been removed.
NOTE:
NOTE:
NOTE: The Reactor and heated hose must be at
the same ambient temperature to get the most
accurate calibration.
NOTE:
NOTE:
NOTE:
A minimum of 50 ft (15.2 m) hose is required
for proper operation while in Resistance Control
Mode.
1. Tap
. Go to Setup
Setup
Setup > Heat
Heat
Heat.
2.
Tap Calibrate
Calibrate
Calibrate
.
3. Tap Continue
Continue
Continue
to acknowledge
the reminder to have the hose at ambient
conditions.
4. Wait while the system measures the hose
resistance.
NOTE:
NOTE:
NOTE: If hose heat was on prior to the
calibration procedure, the system will
wait up to five minutes to allow the wire
temperature to equalize.
5. Tap Accept
Accept
Accept
to proceed with the
calibration, or Cancel
Cancel
Cancel
to stop the
calibration.
NOTE:
NOTE:
NOTE: A temperature estimate will be
displayed if the system was able to measure
the hose wire resistance.
Calibrate
Calibrate
Calibrate the
the
the Transfer
Transfer
Transfer Pumps
Pumps
Pumps
After installing a new electric transfer pump,
you must calibrate the transfer pump motor.
1. Tap
. Go to Setup
Setup
Setup > Supply
Supply
Supply System
System
System.
2. If the transfer pump type is set to Electric
Electric
Electric,
change the transfer pump type to Air
Air
Air. Tap
the Transfer
Transfer
Transfer Pump
Pump
Pump (A
(A
(A or
or
or B)
B)
B) Type
Type
Type field. Select
Air
Air
Air.
3. Change the transfer pump type from Air
Air
Air to
Electric
Electric
Electric. Tap the Transfer
Transfer
Transfer Pump
Pump
Pump (A
(A
(A or
or
or B)
B)
B) Type
Type
Type
field. Select Electric
Electric
Electric.
NOTE:
NOTE:
NOTE: Changing the transfer pump type
from Air
Air
Air to Electric
Electric
Electric triggers the calibration
function.
4. If
If
If calibrating
calibrating
calibrating both
both
both transfer
transfer
transfer pumps,
pumps,
pumps, repeat
steps 2–3 for the other transfer pump motor.
5. Confirm there is no or low inlet pressure
in the transfer pump by opening the
recirculation lines (R).
6. Turn on the transfer pumps. The transfer
pumps will slowly move for multiple strokes
and then shift into normal operation.
a. To turn on the transfer pumps
individually: Tap
to turn
on the A-side transfer pump or tap
to turn on the B-side transfer
pump.
b. To turn on both transfer pumps with
the system: Tap
to turn on
the motor. Electric transfer pumps will
automatically turn on with the motor.
3A8500B
39