![background image](http://html1.mh-extra.com/html/graco/qed-autopump-ap4/qed-autopump-ap4_operation-manual_2253256019.webp)
Rev 01
PN: 95358
Page | 18
Cleaning Procedure
To Clean an Aggressive Fluids Pump
Caution:
•
Wear chemically resistant rubber gloves, boots, and coveralls when handling the AutoPump and fluid discharge hose
to avoid skin contact with the fluid being removed.
•
Wear safety goggles when working with the AutoPump System to protect eyes from any splashing or pressure
release.
Removing the Pump’s Casing
1.
Disconnect the air supply, air exhaust, and fluid discharge lines from the pump.
2.
Remove the bolt at the bottom of the pump which holds the inlet screen in place (bottom loading pumps only).
3.
Remove the three bolts at the bottom of the pump which hold the inlet in place.
4.
Remove the inlet from the pump’s casing by pulling it out.
5.
Twist and slide the casing down off the pump’s frame.
Cleaning the Pump Interior
•
The inner workings of the pump should now be exposed for inspection and cleaning.
1.
Gently brush off built-up solids from the float, discharge tube, pump casing and control rod.
2.
The bottom “spider” casting should be removed by unthreading it from the discharge tube
(part of frame).
3.
For Xtreme models, after removing the spider the Auger can be slide off the discharge tube.
4.
Visually inspect the discharge tube for scale build-up or debris. Also, do the same with the float that slides up
and down on the discharge tube.
5.
Should there be scale deposits on either the discharge tube or float, remove the float from the discharge tube
as Follows: Remove the small steel hairpin from the bottom spring cup. Removing the hairpin
and spring cup will allow you to remove the spring, sliding stop and float from the discharge tube.
6.
The discharge tube and head can now be cleaned using a damp cloth. To aid in cleaning, the discharge tube
and head can be soaked in vinegar. To remove tougher build-up, scour pads that are made for non-stick
cookware can be used.
7.
Both the internal and external surfaces of the float can be cleaned using a damp cloth. To aid in cleaning, the
float can be soaked in vinegar. To remove tougher build-up, scour pads that are made for non-stick cookware
can be used.
8.
The white plastic control rod is the next component to be cleaned. The control rod is the item that fits
through the smaller hole in the float plate and is adjacent to the discharge tube in the assembled pump.
To clean the control rod, use an abrasive pad or a razor or utility knife (not sandpaper).
9.
The final component to be cleaned is the outer casing. The fastest and most effective way to clean out
the inside surface of the pump casing is to use a three-stone honing tool. The technique is to move the hone
in and out a half dozen times or so, through each end of the casing. The time for the casing cleaning should
take
no longer than 5 minutes with this method.
The AutoPump is now ready for re-assembly by following
the “
Removing the Pump
’
s Casing
” steps above in
reverse
order.
Notes:
1.
Before threading the bottom “spider” onto the pump’s discharge tube, be sure to wrap the
discharge tube’s
threads completely with Teflon tape.
2.
Before inserting the two assemblies back into the pump’s casing, apply PTFE grease to the two o
-
rings
to make the next disassembly easier.
3.
When installing the (3) bolts that hold the inlet onto the bottom of the pump, these are to be
torqued to 75 in-lbs.