Appendix B - Advanced Web Interface
Target
In this screen section, view or adjust your
maintenance target, the upper and lower limits
for operator adjustment of flow rate percent, and
maximum and minimum flow rate values. Type the
desired number in the field. Changes made to the
upper and lower flow rate targets will take effect the
next time the operator enters a new flow rate on the
ProControl 1KE Module.
Units
In this screen section, view or adjust the desired
units for pressure, flow rate, batch total, and grand
total. Also enable or disable the pressure sensor
and flow meter. Use the dropdown menu for each to
select different units, or to toggle between Enable
and Disable, if desired.
K-Factor
In this screen section, view or adjust the k-factor for
the system’s meter. See
.
Device Name
In this screen section, type a name in the field to help
you differentiate among ProControl1KEs, if you are
using more than one.
Events
In this screen section, view or adjust the alarm
settings and backlight timer. Use the dropdown
menus to toggle between On and Off for the
maintenance alarm, flow alarm, and auto clear. For
the backlight timer, type a number in the field to
correspond to the number of minutes the display can
be idle before it turns off the backlight to save power.
Modbus
In this screen section, view the modbus mode,
address, baud rate, and parity. Modbus information
must be adjusted on the ProControl 1KE. If you were
to adjust it on your PC, the change would cause a
disruption in your connection.
Date and Time
In this screen section, view or adjust the date format,
date, or time. Use the dropdown menu to select a
new date format, if desired. For date and time, type
the correct information in the field.
3A2614H
51
