![background image](http://html1.mh-extra.com/html/graco/probell-24z221/probell-24z221_instructions-and-parts_2251233028.webp)
Replace
Replace
Replace the
the
the Voltage
Voltage
Voltage to
to
to Pressure
Pressure
Pressure (V2P)
(V2P)
(V2P) Regulator
Regulator
Regulator
Note
This part is not used on Manual Air
Controllers.
Follow these directions to replace the voltage to
pressure regulator (41).
1.
Follow directions at
.
2.
Remove the turbine air solenoid. See
the Trigger or Auxiliary Solenoid Valve, page 27
3.
Disconnect the cable (44) and tube (50).
4.
Remove screws (35) to remove the regulator
assembly, including the bracket (40).
5.
Remove screws (40a) to disconnect the regulator
from the bracket.
6.
Remove the elbows (10, 12),the muffler (61) and
the reducer bushing (69).
7.
Apply thread sealant to the threads on the elbows
(10, 12) and the reducer bushing (69). Tighten
them into the new regulator (41), along with the
muffler (61).
8.
Use screws (40a) to attach the new regulator
(41) to the bracket.
9.
Use screws (35) to attach the assembly to the
controller box.
10. Reconnect the cable (44) and tube (50).
11. Reinstall the turbine air solenoid. See
the Trigger or Auxiliary Solenoid Valve, page 27
.
Also see the calibration procedure on the System
Logic Controller manual, 3A3955, in Inital
Setup/Calibration Screen
.
Note
For better accuracy, perform a “zero clear”
as detailed in the instruction manual that is
included with the V2P regulator. The unit
should be powered on with no air applied.
28
3A3954D