![background image](http://html1.mh-extra.com/html/graco/pm5-238511/pm5-238511_instructions-and-parts-list_2251136012.webp)
12
309377
Operation
Dispensing Fluid in Auto Mode
Before you begin a preset dispense cycle, make
sure AUTO is displayed. If you do not see
AUTO on the display, you are not in the Auto
dispense mode, and fluid flow will not stop when
the auto preset amount is dispensed.
CAUTION
1.
Press the Auto/Reset button.
The display wakes up if it was asleep, and AUTO and
the stored preset dispense amount are displayed. The
factory default is 0.00.
NOTE: To change the stored preset dispense
amount, see Auto Preset Amount on page 9.
2.
You can dispense or change the displayed preset
amount by doing one of the following:
D
Go straight to step 3 to dispense the displayed
preset amount.
OR
D
To change the displayed preset amount, you
can set the display to zero by pressing the
Auto/Reset button, then press the10 button to
change the 10s digit, press the 1.0 button to
change the 1s digit, and press the 0.1 button
the change the first decimal digit. Then go to
step 3.
3.
Lock the trigger. See Locking and Unlocking
the Trigger on page 11.
Fluid flows, and the displayed dispensed amount
counts up from zero. When the preset amount is
dispensed, the unit beeps, the trigger unlocks, fluid
flow stops, the dispensed amount is displayed, and
the meter switches to the Manual dispense mode.
If you want to stop fluid flow before the preset amount
is dispensed, manually unlock the trigger. To continue
the dispense, lock the trigger, and the dispensed
amount resumes counting toward the preset amount.
If you want to continue dispensing after the trigger
unlocks at the preset dispense amount, squeeze the
trigger, and the dispensed amount resumes counting in
the Manual dispense mode until you release the trig-
ger.
NOTE: When the trigger unlocks, the automatic
nozzle prevents the fluid in the extension from running
out.
Viewing Totals
This is the procedure for viewing the non-resettable
and resettable totals. To change the resettable total,
see Resettable Total on page 8.
1.
If the display is blank, press the Manual/Reset or
Auto/Reset button to wake it up.
2.
Press the Total button to view the non-resettable
total amount.
If the unit of measurement is gallons, quarts, or pints,
the total is displayed in gallons, as shown below. If the
unit of measurement is liters, the total is displayed in
liters.
06044A
GAL
TOTAL
! CAUTION
To prevent overfills and spills
Maximum Working Pressure 7 MPa (70 bar, 1000 PSI)
D
Do not obstruct the trigger
D
Do not leave unattended
D
Do not operate below 32
_
F (0
_
C)
D
Read instruction manual
3.
Press the Total button again to view the resettable
total amount.
If the unit of measurement is gallons, quarts, or pints,
the resettable total is displayed in gallons, as shown
below. If the unit of measurement is liters, the reset-
table total is displayed in liters.
06044A
R-TOTAL
GAL
! CAUTION
To prevent overfills and spills
Maximum Working Pressure 7 MPa (70 bar, 1000 PSI)
D
Do not obstruct the trigger
D
Do not leave unattended
D
Do not operate below 32
_
F (0
_
C)
D
Read instruction manual
Pressing the Total button repeatedly toggles between
the non-resettable and resettable total.
4.
Press the Manual/Reset or Auto/Reset button to
return to the Manual or Auto dispensing mode.